- Home
- About Us
- ServicesEssential Services
- Areas We Served
- Testimonials
- Savings
- Careers
- Contact Us
- Home
- About Us
- ServicesEssential Services
- Areas We Served
- Testimonials
- Savings
- Careers
- Contact Us
Furnace Repair, New Furnace Installation, Heat Pumps And Central Air For Brockport, Clarkson And The Town Of Sweden, With Emergency Heating Repair Available Around The Clock. Dalton Heating & Cooling Has Been Family-Owned Since 1989.
From homes along the Erie Canal and Main Street to rural properties in Sweden and Clarkson, Dalton repairs and replaces the full range of heating and cooling equipment found in western Monroe County. Our technicians work on natural gas, propane and oil systems.
Brockport’s Main Street Historic District sits a short walk from newer subdivisions in Sweden and Clarkson, and the heating systems in each are very different. Older village houses often run on hot-water boilers or furnaces that were converted from another fuel, while newer homes usually have a high-efficiency gas furnace and central air. Dalton handles both, from furnace repair on an older system to a full installation in a new build.
A cold-climate heat pump heats and cools from one system, and for homes outside the natural gas lines it can cut heating costs compared with propane or oil. Dalton sizes each system for the house and explains which NYS Clean Heat and utility rebates apply before you commit.
Dalton treats a furnace failure in Brockport as an urgent call. Dalton’s emergency HVAC service takes calls 24 hours a day, including weekends and holidays, and the price is agreed before the repair starts.
Dalton repairs central air conditioners, heat pumps and ductless systems across Brockport and Clarkson. Our technicians check the refrigerant charge, capacitor, contactor, coils and condensate drain, and every AC repair is priced before the work begins.
24/7 emergency furnace and air conditioning repair for Brockport and Clarkson homes.
Furnace, boiler and heat pump repair for every major brand, priced before work starts.
Fall furnace service that keeps equipment efficient and warranties valid.
Free written proposals on new furnaces, air conditioners and heat pumps.
A furnace past 15 years old that needs a major part, keeps failing or has a cracked heat exchanger is usually a candidate for replacement. Dalton prices the repair and the replacement side by side so the decision is yours.
WHAT CUSTOMERS SAY
“The Heating Technicians were courteous and on time. They explained the furnace replacement process and what they were doing each step of the way. They respected my house and removed all of their waste. They were nice to work with and will recommend them for heating and cooling work.”
Sunny
“Good service by knowledgeable people.”
Tom Adler
“Above and beyond service, reasonable rates.”
Kate Bohonos
Overnight, weekend and holiday no-heat calls in Brockport and Clarkson are answered by our own team.
Family-owned since 1989, with the owner still involved in quoting and difficult repairs.
Furnaces, heat pumps and air conditioners sized with a load calculation rather than a rule of thumb.
The diagnosis and the cost are agreed before any part is replaced.
Technicians who service natural gas, propane and oil heating equipment.
Dalton serves the village of Brockport, from Main Street and the Erie Canal to the streets around SUNY Brockport, along with the Town of Sweden, Clarkson and north toward Hamlin. Our technicians also work across western Monroe County, including Spencerport and Chili.
Every service below is available to Brockport, Clarkson and Sweden homeowners, along with water heater repair and replacement.
Sized to the house and quoted in writing.
Diagnosed first, priced before any work.
Fall heating checks and spring cooling checks.
Most furnace repairs cost between $150 and $600. Replacing a flame sensor, ignitor or capacitor falls at the lower end, while blower motors, inducer motors and control boards cost more. Dalton confirms the price in writing before any work begins.
The price depends on the size of the home, the efficiency rating and any venting or ductwork changes, and replacing an older chimney-vented furnace with a high-efficiency model usually requires new PVC venting. Our new furnace cost guide covers typical price ranges in the Rochester area, and every Brockport homeowner receives a free written proposal.
Dirty or failed flame sensors and ignitors are among the most common causes of a furnace that will not stay lit, followed by clogged air filters that make the furnace overheat and shut down. Blower motor and control board failures are less common but more expensive to repair.
Check that the thermostat is set to Heat rather than Fan On and that the air filter is not clogged. If the furnace still blows cold air, the cause is usually a failed ignitor or flame sensor, a tripped limit switch or a fuel supply problem, and a technician should inspect it.
Most 1-inch filters should be changed every one to three months, and thicker 4- to 5-inch media filters every six to twelve months. Homes with pets or allergies need more frequent changes. Our guide on how often to change a furnace filter explains how to choose the right schedule.
A heat pump costs more to install than a central air conditioner, and older models lose capacity in very cold weather. Modern cold-climate heat pumps continue to heat efficiently below freezing, and many homes pair one with a gas or propane furnace in a dual fuel system so the furnace takes over on the coldest days.
Yes. Emergency heating and cooling service is available 24 hours a day, seven days a week, including holidays, throughout Brockport, Clarkson and the Town of Sweden. Call 585-425-8116 to reach our team at any time.
Call (585) 425-8116 or contact us online to schedule furnace repair, a fall tune-up or a free replacement proposal for your Brockport or Clarkson home.
Dalton Heating & Cooling provides HVAC installation, repair and maintenance across these communities: